This is the mail archive of the
cygwin
mailing list for the Cygwin project.
Re: select() too slow
I'm goin to explain everything step by step in order to be now doubts.
One computer with dual boot, Linux in one partition and Windows with
Cygwin installed on another partition.
Boot on Linux compile echo_server.c, run it and it will listen on tcp
port 12345
Imagine that the IP address of the system is 192.168.1.1
Go to some other Linux system on the network, create or choose some
"big_file" you have there and run:
time cat big_file | nc -w 1 192.168.1.1 12345 > /tmp/output
Ok, before w is a dash, it's a matter of charset encoding.
What this command will do is it will cat the big_file and send data
via nc (netcat) to the system where the echo_server is running, then
the echo_server receives the data and sends it back. When done you
will see how much time that process toke. The value 1 after w is to
disconnect nc after 1 second of timeout.
This process, sending a 100 MB big_file takes 22 seconds on Linux.
Now boot on Windows, and imagine that the IP address is 192.168.1.1,
run Cygwin compile echo_server.c, run it and do the same.
The same process takes now 4 minutes sending the same big_file.
I think now it is impossible to detail more the process I'm doing.
Hope that helps to identify what the problem is.
Why it takes so much more time on Cygwin than on Linux?
On 2006/03/14, at 19:18, Christopher Faylor wrote:
On Tue, Mar 14, 2006 at 06:59:28PM +0000, Pedro Inacio wrote:
Hello again,
as promised attached you will find a very simplistic non-blocking
echo server that compiles on Linux and Cygwin.
The main objective is that you compile it and run on both
environments.
Of course that the same hardware is recommended in order to compare
the results in a more accurate way.
After compile and run it, on a different machine you do something
like:
$ time cat big_file | nc ?w 1 echo_server_ip_address port > dest_file
Please provide the *exact* command you used to run this. You don't
have
to provide the "big_file" but the above command contains a garbage
character which can't be what you actually typed. What is
"echo_server_ip_address" and "port" in the above? Again, if you want
help, you are going to have to try harder to explain exactly what you
are doing.
cgf
--
Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple
Problem reports: http://cygwin.com/problems.html
Documentation: http://cygwin.com/docs.html
FAQ: http://cygwin.com/faq/
--
Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple
Problem reports: http://cygwin.com/problems.html
Documentation: http://cygwin.com/docs.html
FAQ: http://cygwin.com/faq/