This is the mail archive of the
cygwin
mailing list for the Cygwin project.
Re: "command not found"-For All Commands
I did send the results of cygcheck...some slight changes since...
"I ran cygcheck, its also attached as a .txt file. Notice how I had to add a
"/" to the command to run it."
-sh-3.2# cygcheck -s -v -r > cygcheck.out
-sh: cygcheck: command not found
-sh-3.2# cygcheck/ -s -v -r > cygcheck.out
cygcheck: dump_sysinfo: GetVolumeInformation() for drive D: failed: 112
-sh-3.2#
I did this again, same results except now I dont have to use "/" when i
write "cygcheck", the results of running the command are the same.
http://old.nabble.com/file/p28725344/nocommandswork.txt nocommandswork.txt
--
View this message in context: http://old.nabble.com/%22command-not-found%22-For-All-Commands-tp28722920p28725344.html
Sent from the Cygwin list mailing list archive at Nabble.com.
--
Problem reports: http://cygwin.com/problems.html
FAQ: http://cygwin.com/faq/
Documentation: http://cygwin.com/docs.html
Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple